Re: Test Fitting My Edmunds Intake

Posted by Ben_Wojdyla On 2013/3/7 13:11:00

I figured the factory carbs worked, but beyond that I'm not sure. They look like they're sized about right for Weber IDA/IDF, and I know some Strombergs fit. As far as routing I'm not totally sure yet. I know the water heater line runs straight down the side. You're looking at the outlet and the inlet looks the side on the other side. I'm assuming the vacuum advance can be tapped into the port you see below the rear carb mount, but I'm not sure. The rest I'll have to figure out.

For my purposes this is all I really need.