Brake lines

Posted by Craig Hendrickson On 2014/2/16 15:10:09

We had to custom make some brake lines of course. A coupler was used to connect to the rear. We took that line off and pulled it out to make connection easier, but you should be able to figure that out. The front line connected to the existing brake block noproblemo. Previous to this part of the install, Lance had gone to the local NAPA store to get a couple of brass adapters (shown). After measurement, we both went back to the NAPA store to get the correct length brake lines with preformed double flare lines.





Like I posted before, CAKE (as in piece of).

Craig