Re: Rear Sway bar
Posted by Craig Hendrickson On 2015/6/6 9:40:09
Mounting the bottom of the Gen-2 Firebird anti-sway bar was more work, but came out very well.
I used the existing hole in the rear axle tube mount-to-trailing arm as one point. I had to temporarily separate the mount from the trailing arm in order to remove the rubber biscuit and washer and trim same a little bit to make room for the head of the outrigger mounting bolt, as shown:
The outrigger was pretty simple, but it had to be robust. Here's a few pictures showing the sequence of parts and their install:
I used the existing hole in the rear axle tube mount-to-trailing arm as one point. I had to temporarily separate the mount from the trailing arm in order to remove the rubber biscuit and washer and trim same a little bit to make room for the head of the outrigger mounting bolt, as shown:
The outrigger was pretty simple, but it had to be robust. Here's a few pictures showing the sequence of parts and their install:
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=162725