Re: Engine swap

Posted by HH56 On 2022/11/20 12:52:45

Quote:

The only specific article I remember in replacing engines of that era is replacing the discontinued 356 with a later engine. There were a number of items that transfered between engines as well as some mods to parts and new holes that need to be drilled in the crossmember to accommodate the different length engine.https://packardinfo.com/xoops/html/downloads/SC/SC-VOL27NO7.pdf

There were also followup articles a few issues later on some changes in the procedure and some new parts that were made available so original components did not need to be modified. You might be able to get some ideas from that procedure on what is needed to replace a 282 but since the engines are a bit different I think there are still some things you would need to figure out.

I believe but will not swear to it that the transmissions will bolt since they used the same trans design until 54. The only significant case difference I recall reading of is the addition of an extra pair of mounting holes in the 48 case redesign so earlier side mounts could bolt. You might check the parts manual to see if there are any years the same parts were used.

Driveshaft may be an issue as is since the length of the bellhousing could be different and might move the transmission a bit.