Re: 1955-56 V-8 headers?

Posted by Craig Hendrickson On 2013/6/24 12:02:30
cli55er Quote:
is the tang on the draft tube connected to the bolt on the engine? if so i stand corrected, but i believe it should be closer to the motor. i'll have to look at mine again.


Hank,

On my 55 Pat and 55 Clipper, the outlet of the road draft tube goes between the frame and the main torsion bar and that's where it is on the mockup.

Quote:
the trans cooler lines....man those will be a tough one with the way the pipes are going. might have to reroute the cooler lines.


Rerouting trans cooler lines is SOP for many header installs. But, I believe on the T-U, they run next to the block, so that should be no problem or a minor problem with these headers.

Craig

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=125922