MrPushbutton Quote:
If you would like I can run any specs you have past him, he'd probably enjoy looking it over.
Ok, I'll bite. From Dyno2000 Computer Engine Simulation v3.10:
My Panther engine with custom Lazer high performance regrind:
Details on the cam profile (regrind on original cam):
Dyno output graph:
Above graph in chart form with additional data:
The engine has stock 1956 cast iron 2x4 intake with 2 500CFM carbs, gasket matched heads with 3-angle valve job and my custom 3-tube headers. This is a 4-speed stick shift setup, so idle was not too big a concern, hence the 108deg CL of the cam. I have all these parts, so this is not some "bench racing" deal.
402HP at 5500RPM, 436Ft-lbs at 4000RPM.
Craig
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=149525