Re: 55-56 oil pump
Posted by R H On 2014/4/6 23:56:28
oil pump ready for assy.
bushings dist. top bushing top, another packard why, i can see the large hole for wick in fill tube, but on the oppiste side they have a hole the size of the bottom bushing, the bushings do have grooves ,,so oil can drop down to lower bushing. how can that big hole hold oil?,, 1/8 inch with grooves seems to me would hold better.
the dist shaft,, these could be made by cnc lathe ,,,whip them right out..
getting that plate off is a b, it is on there..
the lower bushing, my shaft down there is worn, and another a got ,is worn there, so it was not getting oil, enough oil,,
maybe a seal on the bottom, ?, but if too much oil was on shaft that would cause problems too.. a relief hole above bushing to throw out excess oil?
i do not have a small bushing puller, so i had to push the bushing all the way down the dist. pushed both out,
Attach file:
(87.00 KB)
(54.64 KB)
(71.04 KB)
(56.06 KB)
(67.38 KB)
bushings dist. top bushing top, another packard why, i can see the large hole for wick in fill tube, but on the oppiste side they have a hole the size of the bottom bushing, the bushings do have grooves ,,so oil can drop down to lower bushing. how can that big hole hold oil?,, 1/8 inch with grooves seems to me would hold better.
the dist shaft,, these could be made by cnc lathe ,,,whip them right out..
getting that plate off is a b, it is on there..
the lower bushing, my shaft down there is worn, and another a got ,is worn there, so it was not getting oil, enough oil,,
maybe a seal on the bottom, ?, but if too much oil was on shaft that would cause problems too.. a relief hole above bushing to throw out excess oil?
i do not have a small bushing puller, so i had to push the bushing all the way down the dist. pushed both out,
Attach file:
(87.00 KB)
(54.64 KB)
(71.04 KB)
(56.06 KB)
(67.38 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=142202