Re: 1947 R9 Overdrive

Posted by BDeB On 2015/8/13 11:44:38
Quote:

Packard 1947 wrote:
Well I suspect that if I bought the four pinion set and it would not fit, all I would have to do would be to replace the worn parts on mine with the good parts from the four pinion set. I can't see why the needle bearings and the shafts would be different.


They probably are the same but the shafts are held in place by small pins that are covered by the crimped on oil shield. Easy enough to remove the shield but not so easy to replace it.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=165258