Re: Craig's Panther Project - Rollbar 8-point system

Posted by Craig Hendrickson On 2017/1/2 20:30:53

The next challenge was that there was no where to weld the front downbars! The front outrigger was too far forward and the next one back was too far to the rear. So, we just fabricated a new outrigger in-between those two with an underlying angle gusset for strength and had the welder attach it to the frame at top and bottom just like the original outriggers:



The rest was just cutting the end of the downbar to the correct angle and welding it in place. It is not going anywhere, even in a side impact.