Re: Building a 440" Packard V8
Posted by Jack Vines On 2017/2/9 18:36:09
[b]Kids, don't try this at home! It's taken many years and many dollars, but it's getting closer.
First up is finding a forged crankshaft. As most of you know, these were most likely never installed in production engines, but only available a service items after production ceased, so quite rare. Then finding an old school shop which will still build welded strokers; also quite rare. It took him three years to git 'er done, but here's a 3.875" stroke crank.
jack vines
First up is finding a forged crankshaft. As most of you know, these were most likely never installed in production engines, but only available a service items after production ceased, so quite rare. Then finding an old school shop which will still build welded strokers; also quite rare. It took him three years to git 'er done, but here's a 3.875" stroke crank.
jack vines
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=187879