Re: Thoughts on how to fill pinholes in a disk brake backing plate...

Posted by D-train On 2017/9/26 18:54:39
Yes, to be clearer, I am looking to give it some strength back.

I did think about the lead further and figured that with the amount that I would use, I would be melting the stuff that I just put on, as I go.

I'm not sure that it could withstand the heat of brazing either.

I did think about JB weld. I think that I have some of that around. ...somewhere.

My fallback would be rusty metal primer and Rusto over that.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=196129