Re: Packard Engine to GM Auto Transmission Adapters
Posted by DavidPackard On 2021/6/15 23:28:41
If it was a standard shift flywheel the bolts are torqued to 55 - 60 ftlbs . . . that would be for a 7/16 X 20 thread diameter and pitch.
I looked in the Ultramatic section of the shop manual and came up empty.
Assuming the crank shaft is the same Ultramatic v Standard we can assume the crank is good to 60 ftlbs. Now the question is what grade bolts did you buy?
Another question would be how much of a lubricant is Loctite ?
dp
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=234371