Re: Load Pin Questions
Posted by jt fugere On 2009/6/2 18:01:20
I fabricated a "tool" to remove these. I am NOT saying this is what you should do, I am just saying it works. Im a bit adventurous and kinda like when the cars fall on me. J/K
I took two pieces of 5/8" all thread, and made some J hooks. I then placed these around the load bearing arm and through the A arms. There is a gap where the hook can come out near the top shock mount. Using large thick washers Tighten em down and the pins can be removed easily. I was a bit nervous but this worked well and I would do it again.
The pins i am making are just like Craigs except i have chosen to make the center piece out of hex stock. Thanks for all the input and feedback. This forum kicks ass!
Attach file:
(49.08 KB)
(51.52 KB)
I took two pieces of 5/8" all thread, and made some J hooks. I then placed these around the load bearing arm and through the A arms. There is a gap where the hook can come out near the top shock mount. Using large thick washers Tighten em down and the pins can be removed easily. I was a bit nervous but this worked well and I would do it again.
The pins i am making are just like Craigs except i have chosen to make the center piece out of hex stock. Thanks for all the input and feedback. This forum kicks ass!
Attach file:
(49.08 KB)
(51.52 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=29820