Re: Solid State Ignition
Posted by Eric Boyle On 2009/11/10 16:26:45
Now, once you get your module and heat sink, as well as the plug, it's time to mount it in a location that's hidden but still gets a lot of airflow. I like to put them behind the grille, as it's easily hidden and gets plenty of air flowing over it to keep it cool. My '94 T-Bird was like this, a good idea IMHO.
The wiring is very simple and straight forward, and you will be using all the wires on the TFI module. #3 and #6 connector on the module can be connected to the + side of the coil, as they're all + switched. Here's a wiring diagram to show you how to adapt this to point control:
Attach file:
(7.85 KB)
The wiring is very simple and straight forward, and you will be using all the wires on the TFI module. #3 and #6 connector on the module can be connected to the + side of the coil, as they're all + switched. Here's a wiring diagram to show you how to adapt this to point control:
Attach file:
(7.85 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=40436