Re: Blown Packard inline 8.
Posted by BRIAN THOMAS On 2009/10/4 17:49:49
Quote:
What? I hope your not serious, thinking the valves would work in that position. I bored out all 16 vavle seats and after all the grinding and port work was done I pressed in the chrome nickel seats. The cam is not stock. Ed Isky a buddy of mine made the cam for me and added a bit od over lap to the profile to clean the cyls out. 120 degrees.
Attach file:
(113.29 KB)
Turbopackman wrote:
I'm assuming you had someone grind the cam to give you some more lift to make up for sinking the seats that far down in the block? If so, who did your cam?
What? I hope your not serious, thinking the valves would work in that position. I bored out all 16 vavle seats and after all the grinding and port work was done I pressed in the chrome nickel seats. The cam is not stock. Ed Isky a buddy of mine made the cam for me and added a bit od over lap to the profile to clean the cyls out. 120 degrees.
Attach file:
(113.29 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=37900