Re: 55 Packard Transmission Cooler Mockup ?
Posted by Kevin AZ On 2009/12/13 18:33:01
Wow! While I was in the garage today you all were having a grand old time.
Here is the mock-up I've decided to go with. Additionally, I'll use steel lines too for the most part. I'm going to cut the steel lines just forward of the fuel pump area & use a short length of rubber hose (3-6") for vibration purposes, then again use steel to the frame and through the holes in the dust pan to the cooler.
I attack it again next weekend.
Attach file:
(143.12 KB)
(118.76 KB)
(150.12 KB)
(196.74 KB)
(157.08 KB)
(206.41 KB)
(180.25 KB)
Here is the mock-up I've decided to go with. Additionally, I'll use steel lines too for the most part. I'm going to cut the steel lines just forward of the fuel pump area & use a short length of rubber hose (3-6") for vibration purposes, then again use steel to the frame and through the holes in the dust pan to the cooler.
I attack it again next weekend.
Attach file:
(143.12 KB)
(118.76 KB)
(150.12 KB)
(196.74 KB)
(157.08 KB)
(206.41 KB)
(180.25 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=42832