Re: M&H Flat head

Posted by steve-52/200 On 2012/2/6 1:42:39

Hi ,thanks for the thoughts which gm hei distributer would fit on the 52 's 327 ?
I was going to get a pertronix ignitor unit and stick it in the old distributer but hadn't thought about the condition of the distributer and if the bushings or bearings were worn out ,My goal is to squeek out as much power out of the engine I can by upgrading components without doing major changes to the engine ,
Ive found a 4 bbl intake and am looking for the wcfd 4 bbl carb to install to upgrade the breathing ,I hear this was a popular mod at the time ,
I wanted to leave it 6v ,pertronix makes a 6v pos ground points eliminator module and they have a matching high output flamethrower coil ,does the gm hei have a ponts eliminator in it?
a powergen is a alternator that bolts up in the generators place and puts out 60 amp, and eliminates the pesky voltage regulator ,Ive found a stock generator pully and they said if I mailed it to them they would install it on the power gen and then ship it to me to install,this ll be great
I put on modern spark wires ,that helped a ton
I put in modern multigrade oil that helped a touch ,the new rings in the engine allowed the discovery that theres been some rebuilds before in its like as its 30,1000's over
i put in a larger capacity 900 cchr 6v forklift battery that helped alot
I looking around for a 288 head to bolt on the 327 ill check out the distributer swap ,is this 6 v pos ground?