Re: ZIS 110
Posted by HH56 On 2009/4/19 13:39:05
We almost did go metric 20 years ago, but there was such a large number of people that could not grasp how to convert or did not want to think about it or that we should have to, the politicians backed off- 
and we have been somewhat at a disadvantage ever since.
The Packard solenoid valve is built into the bottom 9cm or so of cylinder. There is a rubber seal at one end, the coil, then a flange to crimp the assembly to the cylinder tube. The mounting to the entire frame assembly is the ball on the bottom. Fits into a notch and held in by a clip.
Attach file:
(10.03 KB)
and we have been somewhat at a disadvantage ever since. The Packard solenoid valve is built into the bottom 9cm or so of cylinder. There is a rubber seal at one end, the coil, then a flange to crimp the assembly to the cylinder tube. The mounting to the entire frame assembly is the ball on the bottom. Fits into a notch and held in by a clip.
Attach file:
(10.03 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=26584