Quote:
Turbopackman wrote: Gerd,.......I'm going to see if I can dig up a used Packard head gasket to mail to you to fit on that engine......
Eric & Gerd,
Rather than go to the expense of shipping a gasket, a few discrete measurements of center-to-center stud distances should narrow down the interchange possibilities. I doubt whether rolling or folding a used gasket, to save postage costs in a smaller parcel, would be conducive to obtaining a good fit. That said, agree which studs would give meaningful comparison, then measure away. Also head length, width and depth would be interesting to know.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=37567