Re: Packard Swap Meets. Where are they?

Posted by Bill On 2009/1/10 0:56:39

Quote
"Dan Yocum, should be there, who has lots of trim and parts for 51-56 Packards."

Kev,
When you go to the swap meet and rub elbows with Dan, tell him Bill Steiner from Louisiana sends a hello and his prayers.
You mentioned Dan to me and after contacting him he has been very instrumental in lending me a front spindle, yoke and steering arm for the disc brake project at RPM Engineering in California for my 56 Executive. I couldn't have done this from here in Louisiana without his help.
There are also others that assisted me from California and when I am finished I will enter full project in forums.

Thanks
Bill