Re: '54 fuel filter coupling...
Posted by HH56 On 2012/8/9 10:49:03
Not sure what you're calling a bolt. If you mean the adapter between tube and filter casting similar to this, then the typical Packard size is 5/16" inverted flare for the tube side to 1/8" pipe into the casting. There are also 90 degree fittings used but in the same sizes.
That does depend on the filter brand and different mfgs might have used different sizes in the casting. If you have an aftermarket filter, then maybe different. If this is not the piece you mean, then a picture would be helpful.
Attach file:
(22.58 KB)
That does depend on the filter brand and different mfgs might have used different sizes in the casting. If you have an aftermarket filter, then maybe different. If this is not the piece you mean, then a picture would be helpful.
Attach file:
(22.58 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=107303