Re: Retainer and Clip Sizes

Posted by BigKev On 2013/2/19 23:59:41

Thanks guys. From what I understand and remember, if the holes are round, it takes a clip with a stud and a nut/seal on the backside. If the hole is square, then it takes a push in wire style clip.

The problem is that the trims are different between models and years. So unless someone knew the sizes of those exact part numbers, or the size for the trim off a '54 Deluxe, it may not be the same. Guess I just need to measure the trim at the various locations and figure out the width needed. I will report back.