Re: Rear main oil seal on 288 very tight
Posted by Tim Cole On 2013/5/4 5:34:10
Dear Larry:
Given you have the motor out of the car, why not pull the bearings out of the caps and see if it turns then. I'd also put a little silicone grease on it. Then try seating the thing using a bar on the crankshaft.
Packard specified a wooden dowel of same diameter as crankshaft.
Hope this helps.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=122342