Re: Interchangeability question

Posted by Mark Hill On 2013/8/4 16:16:07

Main concern would be the rear axle. If the shafts fit, that could be a good thing, as I am having an issue with the rear pass. side. Taper contact is only about 2/3rds and the drum is going past the end of the shaft. Have tried another drum, but the contact area ends up being the first 1/3 of the shaft. This drum was loose when I got the car and figure that the large end of the taper on both shaft and drum are worn. Will have to see the car. From what I've been told it's a bit of a field car, so I suspect the frame may be done. Thanks gentlemen!