Re: Easamatic Rebuild Sources

Posted by HH56 On 2013/8/19 13:13:41

Looks like a typical very complete kit and the only thing missing is the same that is not included on any kits -- the conical spring for the compensator valve and any rubber parts for the vacuum power piston. Hopefully you will not need either.

One thing to check carefully is the condition of the sealing surface in the hydraulic section of the pot metal casting. If the seal is new and the piston is new but there is corrosion or pits in the seal seat area of the casting, not much will be gained.

Not following at all the comment about the poppet valve and wider part in the reservoir end vs later units with a poppet in the pressure side.