There is a discussion on the PAC forum but since this one is more active, a question for the 22-23 guys on heater switch construction or application.
Tucson Packards has a switch labeled as 48-50 with 3 terminals. A photo BDeB posted shows a switch with a resistor assy on the end. Do not see a third terminal on that switch although it may just be the angle of the photo.
The question: Is the resistor assy a separate piece and if so, how does it attach. If it is not separate but a part of the switch assy, then what is the application of the switch for sale that it would need 3 terminals or is the switch misidentifed?
Only found one heater switch listed in the accessory section. Were there revisions or more than one?
Attach file:
(17.79 KB) (20.20 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=132054