Re: Howdy

Posted by Sloride75 On 2013/12/29 20:00:43

Thank you, Howard, for the direction on the dowel pin. I have a local mom-n-pop hardware store in mind that I believe will have what I need.

As for the fuel pump, the shaft I took out was peened - so in grinding off the end I precluded its re-use. The supplied shaft has a groove on each end, but the supplied clips are too loose on the groove. When I rebuilt the pump, I used "E" clips from the "variety pack" that didn't fit perfectly, but I thought they would hold. They didnt - hence my suspicion on their quality.