Re: Howdy

Posted by HH56 On 2013/12/31 0:25:31

I think you did a nice job on it but I'm probably not the best to ask on whether it will hold up. Others have more expertise so I'd hope you get a better answer.

If not, IMO the thickness is probably OK since there shouldn't be much deformity or pressure trying to blow thru. It is hard so if there are some surface problems then annealing or perhaps one of the high temp exhaust gasket rated sealers might be a good idea.

Once the manifolds are bolted on the engine and joint is aligned, then the mating joint is tightened so I would think it would hold.