Regarding the gauge, I agree it would be near impossible to find, and I don't think it is too awefully critical, compared to where I was before. Since the approximate range of motion is 90*, I think "between 30* and 45*" is roughly equivalent to 1/4 and half throttle, no? I used two tiny washers, trimmed with a dremel, as seen below. I now have continuity in the switch at around half throttle, which is way closer than I was, and I think an acceptable approximation. Woot!
Attach file:
(65.77 KB)
(50.35 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=137798