Re: 21-23series gas filler lid springs
Posted by BDeB On 2014/5/18 17:28:20
Wire diameter is indeed .063"
OD of the coils is 3/4" and the length from the end of the coil to the first bend is approximately 3/4" for both ends
Offset for the end with the double bend is about 5/32"
Angle on the original is 70 degrees
Here are some photos of the spring for the front of the filler door.
Attach file:
(85.72 KB)
(76.21 KB)
(77.41 KB)
OD of the coils is 3/4" and the length from the end of the coil to the first bend is approximately 3/4" for both ends
Offset for the end with the double bend is about 5/32"
Angle on the original is 70 degrees
Here are some photos of the spring for the front of the filler door.
Attach file:
(85.72 KB)
(76.21 KB)
(77.41 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=144369