Re: 47 loom layout

Posted by JWL On 2014/10/15 11:14:06

Howard, as I recall there are no wiring loom clamps in the engine compartment. The loom enters/exits through a hole in the cowl wall and covered with a spoon-shaped metal retainer. The loom is then routed down to the starter area and on the LH side of the engine compartment on the upper edge of the splash shield just below the hood ledge above the battery. There are two or three retainers on the horizontal bracket in front of the radiator where the wires for the front RH lights are routed. I hope this helps.

(o{}o)