Re: OD Lockout cable removal?

Posted by HH56 On 2014/11/3 21:01:07
The aux disconnect plug may actually be 6 individual wade type connectors located approx 3 ft away from the trans tucked in somewhere close to the L side frame rail just behind the pedal area where the diagonal attaches to straight rail. There was a bulletin mentioning intermittent moisture problems with the connectors and advising they be eliminated and wires spliced and soldered if the problem exhibited. Later harnesses had the connectors eliminated totally and was a solid run from engine cmpt. Your car could have the connectors but may have been eliminated or later version harness.

I believe the 19YR to carb switch is in about a 3' or so stretch of 2 or 3 wires coming straight off the main loom. Starts somewhere close to all the wires exiting in the OD relay & regulator area. If you have the EC accelerator sw it most likely starts where those exit. If three wires, then believe 2 of the wires go to carb sw and the third to heater motor.

Believe the OD light wire is part of the main loom and will be in the bunch of wires that exits straight to relay. 3 or 4 that exit topside of relay just past those going to regulator.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=152488