Re: 21-23 series rubber sill plates.

Posted by Clemens On 2015/1/18 14:13:16

If you really want to build another mold from scratch, I would rebuild the sill plate with a board of sanded hardwood and cut the strips from a block of timber to make sure they all have exactly the size I want them to have. Glue the strips to the board as well as the packard labels taken of your existing results and take your plaster mold off that.

But I don't think it is necessary. Compare these two pictures:


Only very minute differences can be seen or should I say imagined?

By the way: While you're at it, could you make front sills for me?


Regards,
Clemens