Re: Rear Windshield Lower Belt Moulding Joiner Clip
Posted by HH56 On 2015/6/17 13:24:16
Believe you will find them held by a stud welded to the clip which goes thru the gasket and then a retainer piece and nut on the inside. On most if not all models the entire lower belt molding under the window is held in a similar fashion with stud type clips that slide into the molding and then nuts on the inside.
Remove the inner garnish molding -- should be easy to do because it is only held with sheet metal screws -- and see if you don't find several clips holding things together like these on a 55. IIRC, BigKev also may have some photos in his blog.
Attach file:
(24.05 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=163184