Re: 1941 Windsheild trim removal

Posted by custo eight On 2016/3/14 14:37:33

Though I am not that familiar with the 41 model, there are a number of similarities between that and my 47 21st series. It may be the case that the stainless trim is clamped over the pinch weld and becomes the new "pinch weld" to which the rubber clips over. Cut the old rubber away, remove the center clip (rear) or center rail (front). I think you can remove it by working it inwards into the opening after the glass and rubber are cut away.
I struggled trying to figure how it was installed. Finally it made sense.
The sd card above simulates where the pinch weld fits. This looking as from the inside of car .

Attach file:

---

  (95.53 KB)


  (55.39 KB)