Re: Electronic Ignition conversion report
Posted by Moms 54 On 2016/10/28 21:20:02
Ok Thank you all.
I finally had the chance to pick back up on 54' after about a year.
I did install the pertronix solid state and flame thrower coil for the 6v Positive ground.
I had a new set of wires and plugs but I can not find them so I'll start with another fresh set.
I do remember pertronix told me do not use the solid copper wires but I figured I'd ask on here for opinions.
Two of the parts stores have the Champion RJ12CY plugs in stock which I ran before.
My new missing plugs were the Autolite. 308 and I was told I could use them even though I have the Delco system is this true?
Eventually I will get the cloth solid core wires but for now I will go with surrpression wires.
Any thoughts or options on a non-resistance plug?
I will keep the points on hand just in case...
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=183827