Re: 48 Deluxe Project - First Hurdle - Starting

Posted by Icescreamer On 2018/2/25 21:24:12

Scratch that, I found some details on ignition switch removal

--

If you want to remove the ign switch, depending on type it removes one of two ways. If it has a bezel that is fairly thick metal -- maybe 1/4" -- with squarish front and back side, that unscrews from the switch and switch just pulls out from the rear. If the bezel is fairly thin metal with a sloped or rounded contour -- maybe 1/4" near the key opening tapering to a very thin section at the dash, those are spring loaded. The switch has to push into the dash from the rear to relieve the spring and then while the switch is being held in, the bezel is turned a quarter turn to line up a slotted opening