Re: Series 23 Curved Rear Window Glass

Posted by Joe Wareham On 2018/7/23 10:28:31
I've had several posts recently explaining the difficulty I was having installing the rear window glass. It turns out it was my failure to understand how Packard installed the rear glass and headliner. There was a tack strip installed around the inside of the the rear window opening to tack the headliner. The headliner had to be installed before the rear glass because the window gasket seal covered the tack strip. I had not planned to install the headliner before the glass so I didn't install the tack strip. I'm going to secure the headliner by gluing it to the body under the garnish molding. This is how a replacement headliner would be installed without having to remove the rear glass. As it turns out, Packard also used the tack strip as a shim/spacer to hold the glass and gasket in place. Trying to install the glass without the tack strip is almost impossible as I have discovered. To correct this, I installed strips of 5/16" thick by 1/2" wide composite tack strip (Bob Drake TS-45983-A) around the rear window. The original was stapled, I used #4 X 1/2" flathead screws. This should take up the space that allowed the allowed to glass to slip and come out of the gasket. Hopefully, the third attempt will be successful!

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=204563