Re: Oil Filter Plumbing

Posted by Owen_Dyneto On 2019/6/17 11:55:49
You don't give much info to analyze. How about some actual pressure numbers? Cold idle, hot idle, hot at road speed? At what pressure is the oil pump relief valve opening (max cold pressure)?

What service if any did you do on the oil pump as part of the rebuild? Did you check the relief valve spring length or try adding a shim? Very thin gasket used on pump cover?
Cover smooth and free of wear pattern? Have you checked the engine bearing clearances?

An oil filter install schematic is on site here, someone will surely locate it for you.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=212593