Re: How bad do my pistons look?
Posted by Jason75 On 2020/2/4 10:45:09
I will be replacing all pistons, rings and even though they look satisfactory the bearings as well.
I am undecided if I should overbore (which I would like to avoid if possible) or if I can just hone.
All cylinders are within the required taper tolerance (0.10 before a overbore is required). Two cylinders are outside of the recommended roundness tolerance (.004 before a overbore is "recommended").
Attach file:
(150.74 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=218818