Re: King Pin Rebuild

Posted by HH56 On 2020/9/20 16:50:40

I believe you may need a reamer and burnisher to set and expand the bushings to fit the new pins. Check out this threadpackardinfo.com/xoops/html/modules/newbb ... .php?post_id=154111#forumpost154111 and also the instructions and illustrations on steering knuckle bushing installation starting on page 3 of the suspension section in the 51-4 service manual.packardinfo.com/xoops/html/downloads/servicemanual5154/Suspension_XVI.pdf

Make sure there is not pronounced lip or burr from previous installations of the cover upsetting the opening. Normally the domed shape will fit and then the taps on the dome will tend to flatten and expand the diameter to tightly fit in the recess.