Re: 54 Convertible Turn Signal Issues

Posted by 54ocmac On 2022/4/14 18:24:46

Hey Howard and Ross,

Again, thanks for the quick replies!

The out-board tail lights on right/left side of the car are the turn signal/brake lights. Both sockets have 1154 bulbs. The in-board lights on both sides are just running lights, but they have 1129 bulbs in them. Not sure why.

There is a difference between the 2 turn signal/brake light sockets. The properly functioning side has the 2 contacts passing through a round piece of unclad G10. I assume there is a single spring under that piece of G10. The non-functioning side has a different internal set-up. There are 2 springs (one for each contact). There is no G10 stiffener on top of those springs. The wire crimped into the contact passes through the spring and the contact rests on top of said spring. I would say that could contribute to the problem except for the fact that light bulb does illuminate,

Tomorrow I will double check the brake lights.

Now, for the switch mechanism, I’ve considered that could be a possible source. Although I have cycled it numerous times thinking there could be some corrosion/dirt, etc., nothing changes. I may remove it tomorrow, as well, so I can get a look at its’ condition.

I’m sure more to follow!