Re: Ultramatic Shifter Shaft seal

Posted by 53 Cavalier On 2023/9/20 17:51:24
Quote:

HH56 wrote:
Make sure about the condition of the shaft. If dirt collected around the old seal or something was gouged in removing the lever or another seal at some past maintenance it could have roughened up the sealing surface and the new seal might have issues if the lip lands in the same spot.


I think part of the problem may be that somebody painted the transmission at some point, seals and all. Sitting for a few years/decades probably didn't help either.

But I'll clean it up and check, as much as possible, for any imperfections on the shaft.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=261834