Re: 46 R9 Overdrive not operating
Posted by HH56 On 2023/9/21 20:20:09
Quote:
And on the R9, when removing or installing the solenoid it is recommended you electrically activate the solenoid to extend the plunger. This enables getting the ball at the plunger end in and out of the groove in the pawl a bit easier. Also take note of the spacer orientation. It is not symmetrical so the two small holes go toward the rear.
Attach file:
sol1.jpg (137.28 KB)
sol2.jpg (34.58 KB)
todd landis wrote:
When you install the solenoid, make sure you rotate the transmission so that the pawl is lined up with an indentation and can manually be pushed in all of the way.
And on the R9, when removing or installing the solenoid it is recommended you electrically activate the solenoid to extend the plunger. This enables getting the ball at the plunger end in and out of the groove in the pawl a bit easier. Also take note of the spacer orientation. It is not symmetrical so the two small holes go toward the rear.
Attach file:
sol1.jpg (137.28 KB) sol2.jpg (34.58 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=261901