Re: Ultramatic
Posted by HH56 On 2024/6/13 12:16:59
For 53 Cavalier.
Here is an illustration of the tool provided in a Service Counselor when Packard advised dealers to drill a new hole for use with the 359 head. I revised that drawing and added the LHD hole distance to the illustration per the measurement given on page 6 in Studebaker Service Bulletin 340.
Somewhere on the Forum Ross gave a simple way to measure to set the cross shaft without use of the tool. Perhaps he or someone else can restate the information or procedure.
Here is an illustration of the tool provided in a Service Counselor when Packard advised dealers to drill a new hole for use with the 359 head. I revised that drawing and added the LHD hole distance to the illustration per the measurement given on page 6 in Studebaker Service Bulletin 340.
Somewhere on the Forum Ross gave a simple way to measure to set the cross shaft without use of the tool. Perhaps he or someone else can restate the information or procedure.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=272790