Re: 22nd Series Tail Light Exploded View?

Posted by BDeB On 2024/6/19 18:01:27

Pretty simple.

Four 1/4" nuts on studs hold the tail light assembly to the body any the entire unit can be removed.

Then 2 slotted screws hold the rear housing to the bezel. The housing is usually marked to show the TOP side and there will be a rubber seal on the internal plate between the upper and lower compartments. The lip on this seal faces up.

The lens is retained by the large rubber gasket for the bezel.

Be carful when installing the bulb sockets in the housing as they only go in one way and it is easy to damage the small retains tabs on the socket. Should be obvious if you look at them closely.

The single filament signal light bulb goes in the upper mounting hole in the housing while the double filament stop and tail light bulb goes in the lower one.