Re: Ultramatic Clutch Disc and Linkage questions
Posted by Mike On 2010/11/7 19:53:42
Starting cleaning parts to put them back together and saw there were what looks like two bushings in the base of the converter hub. (see attached pic) I have a bushing set from kanter here, so i hate to reassemble if i have the parts to replace them. The question is, how do you get these out without hurting anything!? And how do you drive the new ones in to the right depth?!
Also, the steel plate disc that kind of "clicks" into this part of the converter, does it have to go in a certain way for balance? I marked it but having trouble finding marks after cleaning
The outside of the converter is still marked so the two halves will go back together as they were.
I found another large bushing on one of the other converter pieces. I'm going to go back out and continue cleaning and working, but any advice is appreciated.
Attach file:
(71.31 KB)
(84.54 KB)
Also, the steel plate disc that kind of "clicks" into this part of the converter, does it have to go in a certain way for balance? I marked it but having trouble finding marks after cleaning
The outside of the converter is still marked so the two halves will go back together as they were.I found another large bushing on one of the other converter pieces. I'm going to go back out and continue cleaning and working, but any advice is appreciated.
Attach file:
(71.31 KB)
(84.54 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=63767