Re: Manual Trans re-gasket and seal advice?
Posted by Tobs On 2010/12/20 14:43:59
Well, spent a day in the garage getting dirty.
So far I only took the cover off of the transmission, and did not find any missing teeth on any gears, which I consider good. The two brass 'fingers' on the front shifter forks are pretty worn though, the rears look good still. Is this a result of the front bearing being loose/sloppy?
OK, the trans had slipped out of high gear a few times on me, but not often. I also found the rear transmission mount was torn, so that will also be ordered soon.
Any help appreciated.
Attach file:
(140.96 KB)
(94.14 KB)
(97.58 KB)
(158.33 KB)
So far I only took the cover off of the transmission, and did not find any missing teeth on any gears, which I consider good. The two brass 'fingers' on the front shifter forks are pretty worn though, the rears look good still. Is this a result of the front bearing being loose/sloppy?
OK, the trans had slipped out of high gear a few times on me, but not often. I also found the rear transmission mount was torn, so that will also be ordered soon.
Any help appreciated.
Attach file:
(140.96 KB)
(94.14 KB)
(97.58 KB)
(158.33 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=66910