Re: Sanding Car ready for Paint

Posted by BigKev On 2010/12/24 12:06:46

This is the data sheet on the primer I use. It's not cheap, but in the long run it ends up being worth the cost since it is direct to metal (no 'pre-etch' required), and can be over reduced to create it's own sealer.packardinfo.com/xoops/html/modules/newbb ... p?attachid=1240511351&post_id=26940

Take a read back through my project thread, it may answer many of your questions as I cover a lot of things from beginning to end.

I would use a modern urethane paint. If you don't want the modern Clear/Base Coat gloss, then you just spray it single stage (no clear coat).