Re: Ultramatic Test Gauge fittings

Posted by HH56 On 2011/4/13 15:57:27

It looks as if you are somewhat set. Looking at an old TU, every port I can get to (can't see all) is 1/8 pipe on the outside and needs the straight fitting as shown on your top hose. The service manual does have you make a special tee fitting in checking converter out pressure. Inside the pan, for throttle pressure there is a 1/8 elbow (looks like street or a 45) needed in addition but without the special adapter setup and pan, don't think you can measure those. There was a larger fitting somewhere but think it was on regular ultra.